Users Guide

Ipmacacl number Enter the keyword ipmacacl and then the number of FP blocks
for IP and MAC ACL. The range is from 0 to 6.
ecfmaclnumber Enter the keyword ecfmacacl and then the number of FP
blocks for ECFM ACL. The range is from 0 to 5.
nlbclusteracl
number
Enter the keyword nlbclusteracl and then the number of FP
blocks for nlbcluster ACL. The range is from 0 to 2. By default,
the value is 0 and it supports 8 NLB arp entries reserved for
internal functionality.
NOTE: When you reconfigure CAM allocation, use the
nlbclusteracl number command to change the
number of NLB ARP entries.
The range is from 0 to 2.
The default value is 0. At the default value of 0, eight NLB
ARP entries are available for use. This platform supports
up to 512 CAM entries. Select 1 to configure 256 entries.
Select 2 to configure 512 entries. Even though you can
perform CAM carving to allocate the maximum number
of NLB entries, Dell Networking recommends that you
use a maximum of 64 NLB ARP entries.
vman-qos Enter the keyword vman-qos and then the number of FP blocks
for VMAN QoS. The range is from 0 to 6.
vman-dual-qos
number
Enter the keyword vman-dual-qos and then the number of FP
blocks for VMAN dual QoS. The range is from 0 to 4.
Ipv4pbr number Enter the keyword ipv4pbr and then the number of FP blocks
for ipv4pbr ACL. The range is from 0 to 8.
Openflow number Enter the keyword openflow and then the number of FP blocks
for open flow (multiples of 4). The range is from 0 to 8.
fcoeacl number Enter the keyword fcoeacl and then the number of FP blocks
for FCOE ACL. The range is from 0 to 6.
Iscsioptacl
number
Enter the keyword iscsioptacl and then the number of FP
blocks for iSCSI optimization ACL. The range is from 0 to 2.
l2acl number
ipv4acl number
ipv6acl number,
ipv4qos number
l2qos numberl2pt
number ipmacacl
number ecfmacl
number
{nlbclusteracl]
[vman-qos |
vman-dual-qos
number] ipv4pbr
numberopenflow
{4|8} | fcoe
Allocate space to each CAM region.
Enter 4 or 8 for the number of OpenFlow FP blocks.
• 4: Creates 242 entries for use by the OpenFlow controller
(256 total entries minus the 14 entries reserved for internal
functionality)
• 8: Creates 498 entries for use by the OpenFlow controller
(512 total entries minus the 14 entries reserved for internal
functionality)
The fcoe range is 0–6 groups. Each group has 128 entries; the
value given must be an even number. This information is stored
in the NVRAM and is effective after rebooting the switch.
Content Addressable Memory (CAM) 583