Users Guide

• If the rt with the additive option comes after soo, rt adds the communities
soo sets.
Related
Commands
• set extcommunity soo — set the extended community site-of-origin in the route-
map.
set extcommunity soo
To set extended community site-of-origin in Route Map, use this feature.
Syntax
set extcommunity soo {as4 ASN4:NN | ASN:NNNN | IPADDR:NN [non-
trans]}
To delete the site-of-origin community, use the no set extcommunity command.
Parameters
as4 ASN4:NN Enter the keyword as4 then the 4-octet AS specific extended
community number in the format ASN4:NN (4-byte AS number:
2-byte community value).
ASN:NNNN Enter the 2-octet AS specific extended community number in
the format ASN:NNNN (2-byte AS number:4-byte community
value).
IPADDR:NN Enter the IP address specific extended community in the format
IPADDR:NN (4-byte IPv4 Unicast Address:2-byte community
value).
non-trans (OPTIONAL) Enter the keywords non-trans to indicate a non-
transitive BGP extended community.
Defaults none
Command Modes ROUTE MAP (config-route-map)
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
Border Gateway Protocol 570