Users Guide

VRF Enabled
Dell#
Command Modes
To navigate and launch various CLI modes, use specific commands. Navigation to these modes is described
in the following sections.
BGP ADDRESS-FAMILY Mode
To enable or configure IPv4 for BGP, use BGP ADDRESS-FAMILY mode. For more information, see
Border Gateway Protocol IPv4 (BGPv4).
To enter BGP ADDRESS-FAMILY mode:
1 Verify that you are logged in to ROUTER BGP mode.
2 Enter the address-family command.
3 Enter the protocol type:
• For IPv4, enter the ipv4 multicast command. The prompt changes to include conf-
router_bgp_af for IPv4.
CLASS-MAP Mode
To create or configure a class map, use CLASS-MAP mode. For more information, see
Policy-Based QoS Commands.
To enter CLASS-MAP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the class-map command, and then enter the class map name. The prompt changes to include
config-class-map.
You can return to CONFIGURATION mode by using the exit command.
CONFIGURATION Mode
In EXEC Privilege mode, use the configure command to enter CONFIGURATION mode and configure
routing protocols and access interfaces.
To enter CONFIGURATION mode:
1 Verify that you are logged in to EXEC Privilege mode.
2 Enter the configure command. The prompt changes to include conf.
From this mode, you can enter INTERFACE mode by using the interface command.
CLI Basics 55