Users Guide

ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword
multicast to view information related only to ipv4 multicast
routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the keyword
unicast to view information related only to ipv6 unicast routes.
community-list-
name
Enter the name of a configured IP community list (maximum
140 characters).
exact-match Enter the keyword for an exact match of the communities.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added ipv4 multicast and ipv6 unicast parameters.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
The show ip bgp community-list command without any parameters lists BGP
routes matching the Community List and the output is the same as for the show ip
bgp
command output.
The following describes the show ip bgp community-list pass command shown
in the following example.
Border Gateway Protocol 533