Users Guide

Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced the ability to substitute IGP cost for MED when a
peer/peer-group outbound route-map is set as internal.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
You can use the redistribute command to advertise the IGP cost as the MED on
redistributed routes. When you set the route-map with metric-type internal and apply
outbound to an EBGP peer/peer-group, the advertised routes corresponding to those
peer/peer-groups have the IGP cost set as MED.
When you enter the redistribute isis process-id command without any other
parameters, Dell Networking OS redistributes all OSPF internal routes, external type 1
routes, and external type 2 routes. RFC does not support this feature.
router bgp
To configure and enable BGP, enter ROUTER BGP mode.
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
as-number Enter the AS number. The range is from 1 to 65535 (2 byte), from
1 to 4294967295 (4 byte), or from 0.1 to 65535.65535 (dotted
format).
Border Gateway Protocol 521