Users Guide

Only the following ROUTE-MAP mode commands are
supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to drop
all routes).
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced the ability to substitute IGP cost for MED when a
peer/peer-group outbound route-map is set as internal.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
You can use the redistribute command to advertise the IGP cost as the MED on
redistributed routes. When you set the route-map with metric-type internal and applied
outbound to an EBGP peer/peer-group, the advertised routes corresponding to those
peer/peer-groups have the IGP cost set as MED.
Border Gateway Protocol 519