Users Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
A route reflector reflects routes to the neighbors assigned to the cluster. Neighbors in
the cluster do not need not to be fully meshed. By default, when you use no route
reflector, the internal BGP (IBGP) speakers in the network must be fully meshed.
The first time you enter this command, the router configures as a route reflector and
the specified BGP neighbors configure as clients in the route-reflector cluster.
When you remove all clients of a route reflector using the no neighbor route-
reflector-client command, the router no longer functions as a route reflector.
If the clients of a route reflector are fully meshed, you can configure the route reflector
to not reflect routes to specified clients by using the no bgp client-to-client
reflection command.
This command automatically restarts the neighbor session for the configuration to take
effect.
Related
Commands
• bgp client-to-client reflection — enable route reflection between the route
reflector and the clients.
neighbor send-community
Send a COMMUNITY attribute to a BGP neighbor or peer group. A COMMUNITY attribute indicates that all
routes with that attribute belong to the same community grouping.
Syntax
neighbor {ip-address | peer-group-name} send-community [extended |
standard]
Border Gateway Protocol 506