Users Guide

Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced the limit keyword on the S4810.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
After you configure a peer group as passive, assign it a subnet using the neighbor
soft-reconfiguration inbound command.
For passive eBGP limits, the Remote AS must be different from the AS for this neighbor.
Related
Commands
• neighbor soft-reconfiguration inbound — assign a subnet to a dynamically
configured BGP neighbor.
• neighbor remote-as — assign an indirectly connected AS to a neighbor or peer
group.
neighbor remote-as
Create and specify the remote peer to the BGP neighbor.
Syntax
neighbor {ip-address | peer-group-name} remote-as number
To delete a remote AS entry, use the no neighbor {ip-address | peer-group-
name} remote-as number command.
Parameters
ip-address Enter the IP address of the neighbor to enter the remote AS in its
routing table.
Border Gateway Protocol 501