Users Guide

Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information If you apply a route map to a BGP peer or neighbor with the neighbor default-
originate command configured, the software does not apply the set filters in the
route map to that BGP peer or neighbor.
When you configure a route-map for a BGP peer or peer group with the neighbor
default-originate command, the command checks for the existence of the route
in BGP RIB.
Route-map configuration on a BGP peer or peer group works only when the LOC-RIB
contains at least one route.
When you apply a default route to a BGP peer or peer group using the neighbor
default-originate command, changes to the configured default route-map are
applied to the BGP peer or peer group only after a delay of 15 seconds. As a result, you
must wait for a period of 15 seconds before manually resetting BGP using the
clear
ip bgp command.
In case of eBGP, the neighbor default-originate command does not support
extended-community as a non-transtive route-map attribute.
You cannot set this configuration for a peer that is associated with a peer group.
Similarly, you cannot associate a peer to a peer group if that peer is already configured
with these settings.
In order that settings corresponding to the neighbor default-originate
command take effect, you must execute the clear ip bgp command immediately
after you execute the neighbor default-originate command.
neighbor description
Assign a character string describing the neighbor or group of neighbors (peer group).
Syntax
neighbor {ip-address | peer-group-name} description text
To delete a description, use the no neighbor {ip-address | peer-group-name}
description command.
Border Gateway Protocol 488