Users Guide

Version Description
7.7.1.0 Introduced on the C-Series.
Usage Information If you enter the clear ip bgp flap-statistics command without any
parameters, all statistics are cleared.
Related
Commands
• show debugging — view the enabled debugging operations.
• show ip bgp flap-statistics — view the BGP flap statistics.
• undebug all — disable all debugging operations.
clear ip bgp peer-group
Reset a peer-group’s BGP sessions.
Syntax
clear ip bgp [vrf vrf-name] peer-group peer-group-name [ipv4
[multicast | unicast] | ipv6 unicast] [soft {in | out}]
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to reset
the peer group corresponding to that VRF.
NOTE: You can use this attribute on a specific VRF to
remove history routes corresponding to that VRF. You
can also use this attribute to return the suppressed
routes corresponding to a specific VRF to an active state.
peer-group-name Enter the peer group name to reset the BGP sessions within that
peer group.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword
multicast to reset ipv4 multicast routes.
ipv4 unicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword
unicast to reset ipv4 unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the keyword
unicast to reset ipv6 unicast routes.
soft (OPTIONAL) Enter the keyword soft to reset soft configuration.
in Enter the keyword in to re-configure soft inbound updates.
out Enter the keyword out to re-configure soft outbound updates.
Command Modes EXEC Privilege
Border Gateway Protocol 468