Users Guide

For Address Family IPv4 Unicast
BGP table version is 0, main routing table version 0
Distance: external 20 internal 200 local 200
Dell(conf-router_bgp)#
Related
Commands
• show ip protocols — view information on all routing protocols enabled and active
on the E-Series.
bgp router-id
Assign a user-given ID to a BGP router.
Syntax
bgp router-id ip-address
To delete a user-assigned IP address, use the no bgp router-id command.
Parameters
ip-address Enter an IP address in dotted decimal format to reset only that
BGP neighbor.
Defaults The router ID is the highest IP address of the Loopback interface or, if no Loopback
interfaces are configured, the highest IP address of a physical interface on the router.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Border Gateway Protocol 462