Users Guide

bfd enable (Interface)
Enable BFD on an interface.
Syntax
bfd enable
Defaults BFD is enabled on all interfaces when you enable BFD from CONFIGURATION mode.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
8.2.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
bfd interval
Specify non-default BFD session parameters beginning with the transmission interval.
Syntax
bfd interval interval min_rx min_rx multiplier value role {active
| passive}
Parameters
interval
milliseconds
Enter the keywords interval to specify non-default BFD
session parameters beginning with the transmission interval. The
range is from 50 to 1000. The default is 200.
min_rx
milliseconds
Enter the keywords min_rx to specify the minimum rate at
which the local system would like to receive control packets
Bidirectional Forwarding Detection (BFD) 421