Users Guide

is terminated with the seq, permit, or deny commands. The
threshold range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time
period in minutes at which ACL logs must be generated. The
interval range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL in
which you are creating the rule is applied to the monitored
interface.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is five minutes. By default, flow-
based monitoring is not enabled.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.4(0.0) Added support for flow-based monitoring on the S4810,
S4820T, S6000, and Z9000 platforms.
9.3.0.0 Added support for logging of ACLs on the S4810, S4820T, and
Z9000 platforms.
Usage Information
When the configured maximum threshold is exceeded, generation of logs is stopped.
When the interval at which ACL logs are configured to be recorded expires, the
subsequent, fresh interval timer is started and the packet count for that new interval
commences from zero. If ACL logging was stopped previously because the configured
threshold is exceeded, it is re-enabled for this new interval.
If ACL logging is stopped because the configured threshold is exceeded, it is re-
enabled after the logging interval period elapses. ACL logging is supported for standard
and extended IPv4 ACLs, IPv6 ACLs, and MAC ACLs. You can configure ACL logging
only on ACLs that are applied to ingress interfaces; you cannot enable logging for ACLs
that are associated with egress interfaces.
You can activate flow-based monitoring for a monitoring session by entering the
flow-based enable command in the Monitor Session mode. When you enable this
Access Control Lists (ACL) 372