Users Guide

Version Description
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
Related
Commands
udf-id — assigns value for each configured UDF ID in the given UDF TCAM profile.
udf-tcam — creates a context for UDF TCAM.
show config — displays the current UDF-Qualifier-Value Profile configuration.
udf-tcam
Create a context for UDF TCAM.
Syntax
udf-tcam name seq number
To return to the default settings, use the no udf-tcam name seq number
command.
Parameters
name Enter the UDF ACL profile name, up to 64 characters.
number Enter the keyword seq then the sequence number of the Udf-
Tcam table. The range is from 1 to 512.
Defaults None
Command Modes CONFIGURATION
Example
Dell(conf)#udf-tcam ipnip seq 1
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
Access Control Lists (ACL) 346