Users Guide

Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
Related
Commands
ip access-list standard — configures a standard ACL.
ip access-list extended — creates an extended ACL.
show config
Display the current UDF TCAM profile configuration.
Syntax
show config
Command Modes CONFIGURATION-UDF TCAM
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0) Introduced on the S6000, Z9500, and S4048-ON.
Example
Dell(conf-udf-tcam)#show config
!
udf-tcam ipnip seq 1
key innerL3header udf-id 6 packetbase innerL3Header offset 0
length 2
match l2ethertype ipv4 ipprotocol 4 vlantag any
!
udf-qualifier-value ipnip_val1
Dell(conf-udf-tcam)#
udf-id
Assign value for each configured UDF ID in the given UDF TCAM profile.
Syntax
udf-id id value mask
To return to the default settings, use the no udf-id 1-12 value mask command.
Parameters
id Enter the UDF ID range. The range is from 1 to 12.
value Enter the value for the UDF in Hex, up to 24 bytes.
Access Control Lists (ACL) 344