Users Guide

Related
Commands
udf-tcam — creates a context for UDF TCAM.
show config — displays the current UDF TCAM profile configuration.
permit ip
Associate the UDF in IP access-list.
Syntax
permit ip {source mask | any | host ip-address} {destination mask
| any | host ip-address} udf-pkt-format name udf-qualifier-value
name
To remove this filter, use the no seq sequence-number command.
Parameters
source Enter the IP address of the network or host from which the
packets were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,
when specified in A.B.C.D format, may be either contiguous or
noncontiguous.
any Enter the keyword any to specify that all routes are subject to
the filter.
host ip-address Enter the keyword host then the IP address to specify a host IP
address.
destination Enter the IP address of the network or host to which the packets
are sent.
udf-pkt-format
name
Enter the keywords udf-pkt-format then the UDF ACL profile
name.
udf-qualifier-
value name
Enter the keywords udf-qualifier-value then the UDF
qualifier value profile name.
Command Modes
CONFIGURATION-STANDARD-ACCESS-LIST mode
CONFIGURATION-EXTENDED-ACCESS-LIST mode
Example
Dell(config-ext-nacl)#permit ip any any udf-pkt-format ipinip udf-
qualifier-value ipnip_val1
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Access Control Lists (ACL) 343