Users Guide

Example
Dell# show ip community-lists
ip community-list ABC
permit local-AS
deny no-advertise
permit no-export
Dell#
UDF ACL Commands
The following commands are available within each UDF ACL mode.
deny ip
Disassociate the UDF in IP access-list.
Syntax
deny ip {source mask | any | host ip-address} {destination mask |
any | host ip-address} udf-pkt-format name udf-qualifier-value
name
To remove this filter, use the no seq sequence-number command.
Parameters
source Enter the IP address of the network or host from which the
packets were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,
when specified in A.B.C.D format, may be either contiguous or
noncontiguous.
any Enter the keyword any to specify that all routes are subject to
the filter.
host ip-address Enter the keyword host then the IP address to specify a host IP
address.
destination Enter the IP address of the network or host to which the packets
are sent.
udf-pkt-format
name
Enter the keywords udf-pkt-format then the UDF ACL profile
name.
udf-qualifier-
value name
Enter the keywords udf-qualifier-value then the UDF
qualifier value profile name.
Command Modes
CONFIGURATION-STANDARD-ACCESS-LIST mode
CONFIGURATION-EXTENDED-ACCESS-LIST mode
Access Control Lists (ACL) 339