Users Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information
If you configure the set next-hop command, its configuration takes precedence
over the neighbor next-hop-self command in the ROUTER BGP mode.
If you configure the set next-hop command with the interface’s IP address (either
Loopback or physical), the software declares the route unreachable.
Related
Commands
• match ip next-hop — redistribute routes that match the next-hop IP address.
set origin
To manipulate the BGP ORIGIN attribute, configure a filter.
Syntax
set origin {igp | egp | incomplete}
To delete an ORIGIN attribute setting, use the no set origin command.
Parameters
egp Enter the keyword egp to set routes originating from outside the
local AS.
igp Enter the keyword igp to set routes originating within the same
AS.
incomplete Enter the keyword incomplete to set routes with incomplete
routing information.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
Access Control Lists (ACL) 330