Users Guide

seq
To a deny or permit filter in a MAC access list while creating the filter, assign a sequence number.
Syntax
deny {any | mac-source-address [mac-source-address-mask]} [count
[byte]] [log [interval minutes] [threshold-in-msgs [count]]
[monitor]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s sequence
number.
• Use the no deny {any | mac-source-address mac-source-address-
mask} command.
Parameters
any Enter the keyword any to specify that all routes are subject to
the filter.
mac-source-
address
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-
address-mask
(OPTIONAL) Specify which bits in the MAC address must match.
If no mask is specified, a mask of 00:00:00:00:00:00 is applied
(in other words, the filter allows only MAC addresses that
match).
count (OPTIONAL) Enter the keyword count to count packets
processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed
by the filter.
log (OPTIONAL) Enter the keyword log to include ACL messages in
the log.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed
by a value to indicate the maximum number of ACL logs that
can be generated, exceeding which the generation of ACL logs
is terminated with the seq, permit, or deny commands. The
threshold range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time
period in minutes at which ACL logs must be generated. The
threshold range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL in
which you are creating the rule is applied to the monitored
interface. For more information, see “Flow-based Monitoring” in
the Port Monitoring section in the Dell Networking OS
Configuration Guide.
Access Control Lists (ACL) 289