Users Guide

Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Increased the name string to accept up to 140 characters. Prior
to 7.8.1.0, names are up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information You can assign one ingress ACL and one egress ACL (standard or extended) to an
interface.
Related
Commands
• mac access-list standard — configure a standard MAC ACL.
• mac access-list extended — configure an extended MAC ACL.
show mac access-lists
Display all of the Layer 2 ACLs configured in the system, whether or not they are applied to an interface, and
the count of matches/mismatches against each ACL entry displayed.
Syntax
show mac access-lists [access-list-name] [interface interface] [in
| out]
Parameters
access-list-name Enter the name of a configured MAC ACL, up to 140 characters.
interface interface Enter the keyword interface then the one of the following
keywords and the interface information:
Access Control Lists (ACL) 281