Users Guide

• Use the no seq sequence-number command if you know the filter’s sequence
number.
• Use the no permit udp {source mask | any | host ip-address}
{
destination mask | any | host ip-address command.
Parameters
source Enter the IP address of the network or host from which the
packets were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,
when specified in A.B.C.D format, may be either contiguous or
non-contiguous.
any Enter the keyword any to specify that all routes are subject to
the filter.
host ip-address Enter the keyword host and then enter the IP address to specify
a host IP address.
dscp Enter the keyword dscp to deny a packet based on the DSCP
value. The range is from 0 to 63.
operator (OPTIONAL) Enter one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two
ports for the port parameter)
port port Enter the application layer port number. Enter two port numbers
if you are using the range logical operand. The range is 0 to
65535.
destination Enter the IP address of the network or host to which the packets
are sent.
count (OPTIONAL) Enter the keyword count to count packets
processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed
by the filter.
order (OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where 0 is
the highest priority and 254 is the lowest; lower-order numbers
have a higher priority). If you do not use the keyword order, the
ACLs have the lowest order by default (255).
fragments Enter the keyword fragments to use ACLs to control packet
fragments.
Access Control Lists (ACL) 272