Users Guide

• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two
ports for the port command)
port port
Enter the application layer port number. Enter two port numbers
if using the range logical operand. The range is from 0 to 65535.
destination Enter the IP address of the network or host to which the packets
are sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,
when specified in A.B.C.D format, may be either contiguous or
non-contiguous.
count (OPTIONAL) Enter the keyword count to count packets
processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed
by the filter.
order (OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where 0 is
the highest priority and 254 is the lowest; lower-order numbers
have a higher priority) If you did not use the keyword order, the
ACLs have the lowest order by default (255).
fragments Enter the keyword fragments to use ACLs to control packet
fragments.
no-drop Enter the keywords no-drop to match only the forwarded
packets.
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the no-drop parameter.
9.7(0.0) Introduced on the S6000–ON.
Access Control Lists (ACL) 263