Users Guide

• Use the no deny {ip | ip-protocol-number} {source mask | any |
host ip-address} {destination mask | any | host ip-address}
command.
Parameters
ip Enter the keyword ip to configure a generic IP access list. The
keyword ip specifies that the access list denies all IP protocols.
ip-protocol-
number
Enter a number from 0 to 255 to deny based on the protocol
identified in the IP protocol header.
source Enter the IP address of the network or host from which the
packets were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask,
when specified in A.B.C.D format, may be either contiguous or
noncontiguous.
any Enter the keyword any to specify that all routes are subject to
the filter.
host ip-address Enter the keyword host then the IP address to specify a host IP
address.
destination Enter the IP address of the network or host to which the packets
are sent.
count (OPTIONAL) Enter the keyword count to count packets that the
filter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes that the
filter processes.
log (OPTIONAL, E-Series only) Enter the keyword log to enter ACL
matches in the log.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP
values.
order (OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where 0 is
the highest priority and 254 is the lowest; lower-order numbers
have a higher priority). If you do not use the keyword order, the
ACLs have the lowest order by default (255).
monitor (OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL in
which you are creating the rule is applied to the monitored
interface. For more information, see Flow-based Monitoring in
the Port Monitoring section in the Dell Networking OS
Configuration Guide.
fragments Enter the keyword fragments to use ACLs to control packet
fragments.
no-drop Enter the keywords no-drop to match only the forwarded
packets.
Access Control Lists (ACL) 255