Users Guide

Version Description
7.8.1.0 Increased the name string to accept up to 140 characters. Prior
to 7.8.1.0, names were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information
When you have exhausted all the sequence numbers, this feature permits re-assigning
a new sequence number to entries of an existing access-list.
seq
Assign a sequence number to a deny or permit filter in an IP access list while creating the filter.
Syntax
seq sequence-number {deny | permit} {source [mask] | any | host
ip-address}} [count [bytes]] [dscp value] [order] [fragments] [no-
drop]
To delete a filter, use the no seq sequence-number command.
Parameters
sequence-
number
Enter a number from 0 to 4294967290.
deny Enter the keyword deny to configure a filter to drop packets
meeting this condition.
permit Enter the keyword permit to configure a filter to forward
packets meeting this criteria.
source Enter an IP address in dotted decimal format of the network
from which the packet was received.
mask (OPTIONAL) Enter a network mask in /prefix format (/x) or
A.B.C.D. The mask, when specified in A.B.C.D format, may be
either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to
the filter.
host ip-address Enter the keyword host then the IP address to specify a host IP
address or hostname.
count (OPTIONAL) Enter the keyword count to count packets the filter
processes.
bytes (OPTIONAL) Enter the keyword bytes to count bytes the filter
processes.
Access Control Lists (ACL) 252