Users Guide

show ip access-lists
Display all of the IP ACLs configured in the system, whether or not they are applied to an interface, and the
count of matches/mismatches against each ACL entry displayed.
Syntax
show ip access-lists [access-list-name] [interface interface] [in
| out] [vrf vrf-name]
Parameters
access-list-name Enter the name of a configured MAC ACL, up to 140 characters.
interface interface Enter the keyword interface followed by the one of the
following keywords and slot/port or number information:
• For a VLAN interface, enter the keyword vlan followed by
the slot/port number.
• For a Port Channel interface, enter the keyword port-
channel followed by a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
in | out Identify whether ACL is applied on the ingress or egress side.
vrf vrf-name Enter the keyword vrf and then the name of the VRF to display
the access-lists that are configured on either the default or non-
default VRFs.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.5.1.0 Added support for the 4-port 40G line cards on the E-Series.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Access Control Lists (ACL) 245