Users Guide

To delete an IP access-group configuration, use the no ip access-group access-
list-name {in | out} [implicit-permit] [vlan vlan-id] [vrf vrf-
name] command.
Parameters
access-list-name Enter the name of a configured access list, up to 140 characters.
in Enter the keyword in to apply the ACL to incoming traffic.
out Enter the keyword out to apply the ACL to outgoing traffic.
implicit-permit (OPTIONAL) Enter the keyword implicit-permit to change
the default action of the ACL from implicit-deny to implicit-
permit (that is, if the traffic does not match the filters in the ACL,
the traffic is permitted instead of dropped).
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the ID numbers of the
VLANs. The range is from 1 to 4094 (you can use IDs from 1 to
4094).
vrf vrf-name (OPTIONAL) Enter the keyword vrf then the ID numbers of the
VRFs. The range is from 1 to 63 (you can use IDs from 1 to 63).
NOTE: When you specify a single VRF, use the name of
the VRF instead of the VRF ID number. Use the VRF ID
numbers only when you specify a range of VRFs.
Defaults Not enabled.
Command Modes INTERFACE/VRF MODE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
Access Control Lists (ACL) 241