Users Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
8.4.1.0 Introduced on E-Series, C-Series, and S-Series. Support was
added for IPv6 VRRP groups in nondefault VRF instances.
8.3.2.0 Introduced on the E-Series.
Usage Information If you do not specify an option, debugging is active on all interfaces and all VRRP
groups.
show vrrp ipv6
View the active IPv6 VRRP groups. If no VRRP groups are active, the Dell Networking OS returns No Active
VRRP group
.
Syntax
show vrrp ipv6 [vrid] [interface] [brief] [vrf vrf-name]
Parameters
vrid (OPTIONAL) Enter the virtual router identifier for the VRRP group
to view only that group. The range is from 1 to 255.
interface Enter the following keywords and the number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel, and then a number.
• For a VLAN interface, enter the keyword vlan, and then a
number from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of
information on the VRRP groups.
vrf vrf-name Enter the keyword vrf then the name of the VRF to view IPv6
VRRP groups corresponding to that VRF.
Command Modes
• EXEC
• EXEC Privilege
Virtual Router Redundancy Protocol (VRRP) 2126