Users Guide

1 Set the switches with the lowest priority to both.
2 Set the switch with the highest priority to version 3.
3 Set all the switches from both to version 3.
NOTE: Do not run VRRP version 2 and version 3 in the same group for an
extended period of time.
Example
Dell(conf-if-te-1/1-vrid-100)# version ?
2 VRRPv2
3 VRRPv3
both Interoperable, send VRRPv3 receive
both
Dell(conf-if-te-1/1-vrid-100)# version 3
IPv6 VRRP Commands
The following are IPv6 VRRP commands.
• clear counters vrrp ipv6
• debug vrrp ipv6
• show vrrp ipv6
• vrrp-ipv6-group
The following commands apply to IPv4 and IPv6:
• advertise-interval
• description
• disable
• hold-time
• preempt
• priority
• show config
• virtual-address
clear counters vrrp ipv6
Clear the counters recorded for IPv6 VRRP groups.
Syntax
clear counters vrrp ipv6 [vrid | vrf vrf-name]
Parameters
vrid (OPTIONAL) Enter the number of an IPv6 VRRP group; range is
from 1 to 255.
Virtual Router Redundancy Protocol (VRRP) 2123