Users Guide

debug vrrp
Enable VRRP debugging.
Syntax
debug vrrp [vrrp-id] {all | bfd | database | interface | ipv6 |
packets | state | timer}
To disable debugging, use the no debug vrrp [vrrp-id] {all | bfd |
database | interface | ipv6 | packets | state | timer} command.
Parameters
vrrp-id (OPTIONAL) Enter a number from 1 to 255 as the VRRP group
ID.
all Enter the keyword all to enable debugging of all VRRP groups.
bfd Enter the keyword bfd to enable debugging of VRRP BFD
interactions.
database Enter the keyword database to enable debugging of
configuration changes.
interface Enter the following keywords and the interface information:
• For Port Channel interface types, enter the keywords
port-channel then the number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the
VLAN ID. The VLAN ID range is from 1 to 4094.
interface Enter the keyword interface to enable debugging of interface
state changes.
ipv6 Enter the keyword ipv6 to enable debugging for IPv6.
packets Enter the keyword packets to enable debugging of VRRP
control packets.
state Enter the keyword state to enable debugging of VRRP state
changes.
timer Enter the keyword timer to enable debugging of the VRRP
timer.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Virtual Router Redundancy Protocol (VRRP) 2106