Users Guide

system-mac
Reconfigure the default MAC address for the domain.
Syntax
system-mac mac-address
Parameters
mac-address Enter the system MAC address for the VLT domain.
Defaults Not configured.
Command Modes VLT DOMAIN
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage Information
When you create a VLT domain on a switch, the Dell Networking OS automatically
creates a VLT-system MAC address used for internal system operations.
To reconfigure the default MAC address for the domain, use the system-mac
command. The MAC address must be in the nn:nn:nn:nn:nn:nn format. Also
reconfigure the same MAC address on the VLT peer switch.
unit-id
Configure the default unit ID of a VLT peer switch.
Syntax
unit-id [0 | 1]
Virtual Link Trunking (VLT) 2082