Users Guide

• show vlt counters
• show vlt detail
• show vlt inconsistency
• show vlt mismatch
• show vlt role
• show vlt statistics
• show vlt statistics igmp-snoop
• system-mac
• unit-id
• vlt domain
• vlt-peer-lag port-channel
• show vlt private-vlan
back-up destination
Configure the IPv4 or IPv6 address of the management interface on the remote VLT peer used as the VLT
backup link endpoint for sending out-of-band (OOB) hello messages.
Syntax
back-up destination {[ipv4–address] | [ipv6 ipv6–address]
[interval seconds]}
Parameters
ipv4–address Enter the IPv4 address of the backup destination.
ipv6 Enter the keyword ipv6 then an IPv6 address in the X:X:X:X::X
format.
interval seconds Enter the keyword interval to specify the time interval to send
hello messages. The range is from 1 to 5 seconds. The default is
1 second.
Defaults 1 second
Command Modes VLT DOMAIN
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
Virtual Link Trunking (VLT) 2061