Users Guide

Related
Commands
• ipv6 route-import – imports IPv6 routes from another VRF.
ipv6 route-import
Imports IPv6 routes that another VRF leaks using the tag that VRF specifies during export of these routes.
Syntax
ipv6 route-import tag [route-map-name]
Parameters
route-import Enter the keywords route-import to import IPv6 routes into
the VRF.
tag Enter a tag (ASN number) to specify an import route target for
importing routes from another VRF. To import leaked routes
from another VRF, use the same ASN number that is specified as
the export route target at the source VRF.
route-map-name Enter the name of the route-map to filter the imported routes.
NOTE: Use the route-map attribute while importing
routes from the global RTM. Route-maps allow you to
filter routes at the import end based on the matching
criteria that you define in the route-map.
Defaults N/A
Command Modes
• VRF mode
• CONFIGURATION mode
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–ON,
and Z9500.
Usage Information
It is possible to configure multiple import conditions per VRF depending on the
exporting VRF.
Virtual Routing and Forwarding (VRF) 2045