Users Guide

Example
Dell# configure terminal
Dell(conf)# ip vrf red
Dell(conf-vrf)# description "Red Network"
Dell(conf-vrf)# show config
!
ip vrf red 4
description "Red Network"
Dell(conf-vrf)#
Dell(conf-if-te-1/45)# int te 7/46
Dell(conf-if-te-1/46)# no shut
Dell(conf-if-te-1/46)# ip vrf forwarding red
Dell(conf-if-te-1/46)# ip add 100.1.1.1/24
Dell(conf-if-te-1/46)#
Dell(conf-if-te-1/46)#
Dell(conf-if-te-1/46)#
Dell(conf-if-te-1/46)# show config
!
interface TenGigabitEthernet 1/46
ip vrf forwarding red
ip address 100.1.1.1/24
no shutdown
Dell(conf-if-te-1/46)#
ip route-export
Enables route leaking between VRFs. This command exports or shares IPv4 routes corresponding to one VRF
with other nondefault VRFs.
Syntax
ip route-export tag [route-map-name]
Parameters
route-export Enter the keywords route-export to leak or share routes
between VRFs.
tag Enter a tag (export route target) to expose routes to other VRFs.
This tag acts as an identifier for exported routes. Use this
identifier while importing these routes into another nondefault
VRF.
route-map-name (Optional) Enter the name of the route-map to filter the
exported routes.
You can leak global routes to VRFs. As the global RTM usually
contains a large pool of routes, when the destination VRF
imports global routes, these routes are duplicated into the VRF's
RTM. It is mandatory to use route-maps to filter out leaked
routes while sharing global routes with VRFs.
Command Modes
• VRP mode
• CONFIGURATION mode
Virtual Routing and Forwarding (VRF) 2041