Users Guide

Example
Dell(conf)# uplink-state-group 16
Dell(conf)#
02:23:17: %RPM0-P:CP %IFMGR-5-ASTATE_UP: Changed uplink state
group Admin state to up: Group 16
Dell(conf)#
Related
Commands
• show running-config uplink-state-group — displays the current configuration of
one or more uplink-state groups.
• show uplink-state-group — displays the status information on a specified uplink-
state group or all groups.
upstream
Assign a port or port-channel to the uplink-state group as an upstream interface.
Syntax
upstream interface
To delete an uplink-state group, use the no upstream interface command.
Parameters
interface Enter one of the following interface types:
• 10 Gigabit Ethernet: tengigabitethernet {slot/
port[/subport] | slot/port[/subport]-range}
• 40-Gigabit Ethernet:fortyGigE {slot/port}
• Port channel: port-channel {1–128 | port-
channel-range}
Where port-range and port-channel-range specify a range
of ports separated by a dash (-) and/or individual ports/port
channels in any order; for example:
gigabitethernet
1/1-2,5,9,11-12 port-channel 1-3,5. A comma is
required to separate each port and port-range entry.
If a 40G port is fanned-out into 10G ports, the range is entered
as slot/sort/subport-slot/port/subport.
Defaults none
Command Modes UPLINK-STATE-GROUP
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
Uplink Failure Detection (UFD) 2022