Users Guide

Tunneling

Tunneling is supported on Dell Networking OS.

Topics:

• ip unnumbered

• ipv6 unnumbered

• tunnel allow-remote

• tunnel destination

• tunnel dscp

• tunnel flow-label

• tunnel hop-limit

• tunnel keepalive

• tunnel-mode

• tunnel source

ip unnumbered

Configure a tunnel interface to operate without a unique IPv4 address and select the interface from which the

tunnel borrows its address.

Syntax

ip unnumbered interface-type

To set the tunnel back to default logical address use the no ip unnumbered

command. If the tunnel was previously operational, the tunnel interface is operationally

down unless you also configure the tunnel IPv6 address.

Parameters

interface-type

Enter the interface type, followed by a slot/port/subport

number.

Defaults None

Command Modes INTERFACE TUNNEL

Command History

This guide is platform-specific. For command information about other platforms, see

the relevant Dell Networking OS Command Line Reference Guide.

Tunneling 2000