Users Guide

Version Description
9.6(0.0) Added support for VRF.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.4.1.0 Added IPv6 support.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information
You can configure multiple time-serving hosts. From these time-serving hosts, the Dell
Networking OS chooses one NTP host with which to synchronize. To determine which
server is selected, use the show ntp associations command.
Because many polls to NTP hosts can affect network performance, Dell Networking
recommends limiting the number of hosts configured.
By default, the system performs a time synchronization if the time difference from the
time source is greater than one second.
Related
Commands
• show ntp associations — displays the NTP servers configured and their status.
ntp source
Specify an interface’s IP address to be included in the NTP packets.
Syntax
ntp source interface
To delete the configuration, use the no ntp source command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
System Time and Date 1992