Users Guide

mep cross-check start-delay
Configure the amount of time the system waits for a remote MEP to come up before the cross-check
operation is started.
Syntax
mep cross-check start-delay number
Parameters
start-delay
number
Enter a start-delay in seconds. The range is from 3 to 100
seconds.
Defaults 3 ccms
Command Modes ETHERNET CFM
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the S-Series.
ping ethernet
Send a loopback message.
Syntax
ping ethernet domain [name l level] ma-name ma-name remote {dest-
mep-id | mac-addr mac-address} source {src-mep-id | port
interface}
Parameters
name | level Enter the domain name or level.
ma-name ma-
name
Enter the keyword ma-name and then enter the maintenance
association name.
dest-mep-id Enter the MEP ID that is the target of the ping.
802.1ag 199