Users Guide

Defaults Disabled (that is, if you configure an NTP host, all interfaces receive NTP packets)
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
ntp multicast client
To receive NTP information from the network via multicast, configure the switch.
Syntax
ntp multicast client [multicast-address]
To disable multicast reception, use the no ntp multicast client [multicast-
address] command.
Parameters
multicast-address (OPTIONAL) Enter a multicast address. Enter either an IPv4
address in dotted decimal format or an IPv6 address in X:X:X:X::X
format. If you do not enter a multicast address, the address:
• 224.0.1.1 is configured if the interface address is IPv4
• ff05::101 is configured if the interface address is IPv6
Defaults Not configured.
System Time and Date 1989