Users Guide

stop-time HH:MM Enter the keywords stop-time then a stopping time expressed
as HH:MM. Use the 24-hour clock format.
Command Modes SUPPORTASSIST PERSON
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the C9010, Z9100–ON, S6100–ON, and S3100
series.
9.9(0.0) Introduced on the S4810, S4820T, S3048–ON, S4048–ON,
S5000, S6000, S6000–ON, Z9500, MXL.
Usage Information This command is optional for SupportAssist service configuration.
SupportAssist Server Commands
Dell Networking OS supports the following SupportAssist Server mode commands.
proxy-ip-address
Configure a proxy for reaching the SupportAssist remote server.
Syntax
proxy-ip-address {ipv4-address | ipv6-address} port port-number
[ username userid password [encryption-type] password ]
To remove the proxy, use the no proxy-ip-address command.
Parameters
ipv4-address Enter the IP address of the proxy server in a dotted decimal
format (A.B.C.D).
ipv6-address Enter the IPv6 address of the proxy server in the x:x:x:x::x
format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
NOTE: To use the IPv6 address, the Open Automation
package should also support IPv6 communications. For
this purpose, SupportAssist requires Dell Networking
Open Automation 9.10(0.0) package or later.
SupportAssist 1972