Users Guide

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

9.2(0.0) Introduced on the M I/O Aggregator. This command is

supported in Programmable-Mux (PMUX) mode only.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.5.1.0 Added support for 4-port 40G line cards on the E-Series.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.5.1.0 Introduced on the E-Series.

storm-control broadcast

(Configuration)

Configure the percentage of broadcast traffic allowed in the network.

Syntax

storm-control broadcast [packets_per_second in]

To disable broadcast rate-limiting, use the no storm-control broadcast

[packets_per_second in] command.

storm-control broadcast [percentage decimal_value in | out]| [wred-

profile name]]

[packets_per_second in]

To disable broadcast rate-limiting, use the storm-control broadcast [percentage

decimal_value in | out] | [wred-profile name]] [packets_per_second in] command.

Parameters

percentagedecim

al_value in | out

Enter the percentage of broadcast traffic allowed in or out of the

network. Optionally, you can designate a decimal value

percentage, for example, 55.5%. The decimal range is from .1 to .

Storm Control 1930