Users Guide

Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.1 Introduced on the S4810.
8.3.12.0 Reset command mode from EXEC to CONFIGURATION.
Usage Information The following message displays to confirm the command.
Setting ports Fo 1/60 as stack group will make their interface
configs obsolete after a reload.[confirm yes/no]: If “y” is
entered, all non-default configurations on any member ports of
the current stack group will be removed when the unit is rebooted.
NOTE: Any scripts used to streamline the stacking configuration process must be
updated to reflect the Command Mode change from EXEC Privilege to
CONFIGURATION to allow the scripts to work correctly.
upgrade system stack-unit
Copy the boot image or Dell Networking OS from the management unit to one or more stack members.
Syntax
upgrade {boot | system} stack-unit {all | stack-unit-number | A |
B}
Parameters
boot Enter the keyword boot to copy the boot image from the
management unit to the designated stack members.
system Enter the keyword system to copy the Dell Networking OS
image from the management unit to the designated stack
members.
stack-unit Enter the stack-unit number. The range is from 1 to 6.
all Enter the keyword all to copy the designated image to all stack
members.
Stacking 1924