Users Guide

Parameters
stack-number Enter a stack member identifier of the switch that you want to
add to the stack.
model-identifier Enter the model identifier of the switch to be added as a stack
member. This identifier is also referred to as the provision type.
Defaults When this value is not set, a switch joining the stack is given the next available
sequential stack member identifier.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Related
Commands
• reload – reboot the Dell Networking OS.
• show system (S-Series and Z-Series) – display the status of all stack members or a
specific member.
stack-unit stack-group
Configure the stacking unit and stacking group by specifying an ID when adding units to a stack to ensure the
unit is assigned to the correct group.
Syntax
stack-unit unit-id stack-group stack-group-id
To remove the current stack group configuration, use the no stack-unit unit-id
stack-group stack-id command.
Parameters
unit-id Enter the stack unit ID.
stack-group-id Enter the stack group ID.
Stacking 1923