Users Guide

stack-unit priority
Configure the ability of a switch to become the management unit of a stack.
Syntax
stack-unit stack-number priority priority-value
Parameters
stack-number Enter the stack member unit identifier.
priority-value This preference parameter allows you to specify the
management priority of one backup switch over another, with 1
as the lowest priority and 14 being the highest. The switch with
the highest priority value is chosen to become the management
unit if the active management unit fails or on the next reload.
Defaults 1
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Related
Commands
• reload – reboots Dell Networking OS.
stack-unit provision
Preconfigure a logical stacking ID of a switch that joins the stack. This is an optional command that is
executed on the management unit.
Syntax
stack-unit [stack-number] provision {model-identifier}
Stacking 1922