Users Guide

Version Description
E-Series legacy
command
Usage Information
When you enable logging synchronous, unsolicited messages appear between
software prompts and outputs. Only the messages with a severity at or below the set
level are sent to the console.
If the message queue limit is reached on a terminal line and messages are discarded, a
system message appears on that terminal line. Messages may continue to appear on
other terminal lines.
Related
Commands
• logging on — enables logging.
logging trap
Specify which messages are logged to the Syslog server based the message severity.
Syntax
logging trap [level]
To return to the default values, use the default logging trap command.
To disable logging, use the no logging trap command.
Parameters
level Indicate a value from 0 to 7 or enter one of the following
parameters: emergencies, alerts, critical, errors,
warnings, notifications, informational, or debugging.
The default is
6 or informational.
Defaults 6 or informational
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
Simple Network Management Protocol (SNMP) and Syslog 1897