Users Guide

remote ip-address Enter the keywords udp-port then the user datagram protocol
(UDP) port number on the remote device. The range is from 0 to
65535. The default is 162.
vrf vrf-name Enter the keywords vrf and then the name of the VRF this is
used to connect to the SNMP server.
NOTE: Use this attribute to specify a VRF name that is
used to connect to the remote host. If no VRF is
specified, then the default VRF is used.
udp-port port-
number
Enter the keywords udp-port then the UDP (User Datagram
Protocol) port number on the remote device. The range is from
0 to 65535. The default is 162.
1 | 2c | 3 (OPTIONAL) Enter the security model version number (1, 2c, or
3):
• 1 is the least secure version.
• 3 is the most secure of the security modes.
• 2c allows transmission of informs and counter 64, which
allows for integers twice the width of what is normally
allowed.
The default is 1.
encrypted (OPTIONAL) Enter the keyword encrypted to specify the
password appear in encrypted format (a series of digits, masking
the true characters of the string).
auth (OPTIONAL) Enter the keyword auth to specify authentication
of a packet without encryption.
md5 | sha (OPTIONAL) Enter the keyword md5 or sha to designate the
authentication level.
• md5 — Message Digest Algorithm
• sha — Secure Hash Algorithm
auth-password (OPTIONAL) Enter a text string (up to 20 characters long)
password that enables the agent to receive packets from the
host. Minimum: eight characters long.
priv (OPTIONAL) Enter the keywords priv to initiate a privacy
authentication level setting.
des56 | aes128 (OPTIONAL) Enter the keyword des56 or aes128 to specify the
encryption mode.
• aes128 — Use 128 bit AES algorithm in CFB mode for
encryption.
Simple Network Management Protocol (SNMP) and Syslog 1872