Users Guide

snmp-server host
Configure the recipient of an SNMP trap operation.
Syntax
snmp-server host ip-address | ipv6-address [vrf vrf-name] traps |
informs [version 1 | 2c | 3] [auth | no auth | priv] [community-
string] [udp-port port-number] [notification-type]
To remove the SNMP host, use the no snmp-server host ip-address [vrf
vrf-name] traps | informs [version 1 | 2c | 3] [auth | noauth |
priv] [community-string] [udp-port number] [notification-type]
command.
Parameters
ip-address Enter the keyword host then the IP address of the host
(configurable hosts is limited to 16).
ipv6-address Enter the keyword host then the IPv6 address of the host in the
x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
vrf vrf-name Enter the keyword vrf and then the name of the VRF that the
SNMP server uses to connect to the host.
NOTE: You can use this attribute to inform the SNMP
engine about the vrf instance to be used to reach the
corresponding remote host to send Trap or Inform
message. If no VRF is specified, then the default VRF is
used.
traps (OPTIONAL) Enter the keyword traps to send trap notifications
to the specified host. The default is traps.
informs (OPTIONAL) Enter the keyword informs to send inform
notifications to the specified host. The default is traps.
version 1 | 2c | 3 (OPTIONAL) Enter the keyword version to specify the security
model then the security model version number 1, 2c, or 3:
• Version 1 is the least secure version.
• Version 3 is the most secure of the security modes.
• Version 2c allows transmission of informs and counter 64,
which allows for integers twice the width of what is
normally allowed.
The default is version 1.
auth (OPTIONAL) Enter the keyword auth to specify authentication
of a packet without encryption.
Simple Network Management Protocol (SNMP) and Syslog 1865