Users Guide

is a port connected to Router2. This is a port connected to
Router2. This is a
port connected to Router2. This is a port connected to Router2.
IF-MIB::ifAlias.134792448 = STRING:
Dell#config
snmp-server community
Configure a new community string access for SNMPv1 v2 and v3.
Syntax
snmp-server community community-name {ro | rw} [ipv6 ipv6-access-
list-name [ipv6 ipv6-access-list-name | access-list-name |
security-name name] | security-name name [ipv6 ipv6-access-list-
name | access-list-name | security-name name] | access-list-name
[ipv6 ipv6-access-list-name | access-list-name | security-name
name]]]
To remove access to a community, use the no snmp-server community
community-string {ro | rw} [security-name name [access-list-name |
ipv6 access-list-name | access-list-name ipv6 access-list-name]]
command.
Parameters
community-name Enter a text string (up to 20 characters long) to act as a
password for SNMP.
ro Enter the keyword ro to specify read-only permission.
rw Enter the keyword rw to specify read-write permission.
ipv6 access-list-
name
(Optional) Enter the keyword ipv6 then an IPv6 ACL name (a
string up to 16 characters long).
security-name
name
(Optional) Enter the keywords security-name then the
security name as defined by the community MIB.
access-list-name (Optional) Enter a standard IPv4 access list name (a string up to
16 characters long).
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Simple Network Management Protocol (SNMP) and Syslog 1856