Users Guide

Version Description
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information Sample-rate is the average number of packets skipped before the sample is taken. This
command changes the global default sampling rate. You can configure an interface to
use a different sampling rate than the global sampling rate. If the value entered is not a
correct power of 2, the command generates an error message with the previous and
next power of 2 value. Select one of these two packet numbers and re-enter the
command.
Related
Commands
• sflow sample-rate (Interface) — changes the interface sampling rate.
sflow sample-rate (Interface)
Change the interface default sampling rate.
Syntax
sflow sample-rate value
To return to the default sampling rate, use the no sflow sample-rate command.
Parameters
value Enter the sampling rate value. For the C-Series and S-Series, the
range is from 256 to 8388608 packets. Enter values in powers of
2 only; for example, 4096, 8192, 16384, etc. The default is
32768 packets.
Defaults The Global default sampling.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
sFlow 1846