Users Guide

As part of the sFlow-MIB, if the SNMP request originates from a configured collector,
Dell Networking OS returns the corresponding configured agent IP in the MIB requests.
Dell Networking OS checks to ensure that two entries are not configured for the same
collector IP with a different agent IP. Should that happen, Dell Networking OS
generates the following error: %Error: Different agent-addr attempted for
an existing collector.
Example
Dell(conf)# sflow collector 10.1.1.25 agent-addr 10.1.1.10 vrf
management
sflow enable (Global)
Enable sFlow globally.
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced S-Series Stacking.
8.1.1.0 Introduced on the E-Series.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
sFlow 1839