Users Guide

• sflow ingress-enable
• sflow extended-switch enable
• sflow max-header-size extended
• sflow polling-interval (Global)
• sflow polling-interval (Interface)
• sflow sample-rate (Global)
• sflow sample-rate (Interface)
• show sflow
sflow collector
Configure a collector device to which sFlow datagrams are forwarded.
Syntax
sflow collector {ip-address | ipv6-address} agent-addr {ip-address
| ipv6-address} [number [max-datagram-size number]] | [max-
datagram-size number] [vrf management]
To delete a configured collector, use the no sflow collector {ip-address |
ipv6-address} agent-addr {ipv4-address | ipv6-address} [number
[max-datagram-size number]] | [max-datagram-size number] [vrf
management] command.
Parameters
sflow collector ip-
address | ipv6-
address
Enter the IP address of the collector in dotted decimal format
for IPv4 or x:x:x:x::x format for IPv6.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
agent-addr ip-
address | ipv6-
address
Enter the keyword agent-addr followed by the sFlow agent IP
address in dotted decimal format for IPv4 or x:x:x:x::x format for
IPv6.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
number (OPTIONAL) Enter the user datagram protocol (UDP) port
number. The range is from 0 to 65535. The default is 6343.
max-datagram-
size number
(OPTIONAL) Enter the keyword max-datagram-size then the
size number in bytes. The range is from 400 to 1500. The default
is 1400.
vrf management (OPTIONAL) Enter the keyword vrf followed by the keyword
management to configure the collector device corresponding to
the default VRF and the management VRF respectively.
Defaults Not configured.
sFlow 1837